A corner flat is located in the end of the building: that is, part of its walls are not adjacent to the neighbors, however are the outer walls of the house.

There may be one flat in a corner apartment – it occupies the entire end of the house, it’s also known as a corner flat. Or two – that the windows of one forget the road, the second – the lawn. Depends on the building plan, the design of the assumptions.

There’s also a”separate caste” – casing with walls from the expansion joints. These”gaps” between entrances are typically made in multi-story buildings, the main job of the unit – to split the deformation forces during the shrinkage of this construction, in case of emergencies. Pros and cons of both corner apartments in the joint are slightly different from the typical ones with access to the road – we’ll pay particular attention to this subject in the last section.

Infection

Considering that the 2-3 sides of the space is outside, in winter it’s 3-5C colder, and in summertime on the contrary – hotter. Especially if the end of the house is heated by sunlight. In some cases, the gap reaches 10C – however domikday.ru such a difference is improper, indicates that a problem with the exterior the home – most likely have to get in touch with the management company, requesting (or forcing) to fulfill their direct duties, to spot the cracks formed.

Corner flat in a brick house with thick walls is much more comfy. Such risks aren’t exposed – the thickness of the wall acts as a buffer, not letting overheating, overcooling.

Humidity

When an area has just one wall combined with the road, it usually has enough room heat to avoid freezing and warmth. However, if there are two outdoor walls, and they’re adjacent – there is a higher probability of freezing in the corner, the creation of condensation inside, and consequently – mold, fungus. Their spores not only spoil the look of the space, but also lead to the appearance, complication of several serious ailments.

Important! The problems of corner location are compounded when the variables are linked – also low temperature from heating batteries combined with dampness is guaranteed to result in moldy walls.